Paths to the VCL/RTL
|Top Previous Next|
If you use C# Builder, there is already a converted version of the VCL. So you don't have to translate the according files. Nevertheless the translator has to know the interface parts of the original Delphi VCL, to make a correct translation of the files, which depend on the VCL. So you have to set the folders of the original or of the preprocessed VCL.
There might be other files, which don't have to be converted, perhaps because you already have translated them. The paths to those files should be set here too.
The paths of the VCL may look like:
C:\Program Files (x86)\CodeGear\RAD Studio\6.0\source\Win32\vcl
C:\Program Files (x86)\CodeGear\RAD Studio\6.0\source\Win32\rtl\common
C:\Program Files (x86)\CodeGear\RAD Studio\6.0\source\Win32\rtl\sys
C:\Program Files (x86)\CodeGear\RAD Studio\6.0\source\Win32\rtl\win
This page belongs to the Delphi2C# Documentation
|Delphi2C# home Content|